Shop Internationally at Sears
※ Download: Graco pack and play manual
Attach other end of toybar to center connector. COM is for educational use only. Step 4 Cover the Graco Pack n' Play bassinet mattress with a tight-fitting Graco bassinet mattress sheet.
Unsnap the Velcro straps holding the play yard together. We currently do not accept product registrations from those living outside the United States of America. The plastic sides of the bassinet simply snap over the side rails of the frame, one piece on either side of the oval-shaped button in the middle of each rail.
Playards - When setting up, lock rails BEFORE lowering center. Recommended use from birth to 5 months.
KEEP INSTRUCTIONS FOR FUTURE USE. See back page for quick set up guide. NEVER add a mattress, pillow, comforter or padding. Use ONLY mattress pad provided by Graco. Keep strings and your physician. Check that you have all the parts for this model BEFORE assembling your product. If any parts are missing, call Customer Service. ALL MODELS FEATURES ON CERTAIN MODELS... Disconnect straps holding mattress around playard. Remove mattress from around playard. Pull up on side rails in middle above push button until all four sides are locked. DO NOT push center down yet. When setting up, lock rails BEFORE lowering center. Be sure top rails have become rigid. If not, pull up again until they are rigid. If top rails do not latch, lift the center of the floor higher. CHECK that fabric covers corners. Pull the four snap straps on corners of playard mattress through bottom of playard. Wrap around the tube and fasten snap onto the tube. Make sure to fasten the bassinet clips to the playard Always press down on the left side of the clip, then the right as shown. Insert tapered end of bar into end of other bar with hole in it. Repeat with other set of bars. Release snap straps and hook and loop straps on bottom of playard. Pull mattress fully out of playard. DO NOT unlock top rails yet. Pull the center of the playard floor up with the tab in the middle of the playard. Center of floor must be up. Lift up slightly on the top rail. Push in on the button located on the side of the top rail to release the two tubes. Repeat on all four rails until all tubes are released. If unit will not fold, look for a partially latched top rail. Squeeze the latch button to release the rail. Cover unit with handle out. Never leave child unattended. Check that it is supported by the playard by pushing down into center of changing table. If not in this orientation, follow steps 1-3. Press button and pull up unlock and rotate as shown. Rotate until tube opening is on the bottom, then press down to lock it in place. Insert the long end of the tube into the button housing as shown. The metal button should be facing out when snapped in place as shown. With the napper side up, insert the button housing tube as shown. Insert the button housing tube as shown. The metal button should be facing out when snapped in place as shown. The tabs on the sides of the napper will snap in place as shown. Press button and pull up unlock and rotate to the napper side. Push down on the inside of napper until it clicks into place. Check that napper is securely attached by pulling up on it. Do Not print 1. Press button on housing and pull to unlock and rotate to the changer side. Push down on the inside of changer until it clicks into place. Check that changer is securely attached by pulling up on it. Pull up on bassinet clip to detach it from the playard. Repeat steps 1- 2 on the opposite side. Make sure to fasten the bassinet clips to the playard as shown. Remove toy bar when baby begins to push up on hands and knees. Recommended use from birth to 5 months. Attach one end of toybar into center connector. Insert assembled toybar parts into toybar fabric. Attach other end of toybar to center connector. Attach toy to toybar with hook and loop tape. Attach toybar to playard as shown. Child may use as a step to climb out or reach items in bag. Replace or repair the parts as needed. Use only Graco® replacement parts. IF PLAYARD IS USED AT THE BEACH, you MUST clean sand off your playard, including the feet, before packing it into cover. Pull red tab up to unlock. Stop when you hear it click. Lift rail up slightly, press button and lower rail. Repeat on all 4 sides. See page 16 3. Wrap mattress around play yard. Pull up on all 4 sides and snap into place. Do not push center of Playard down until top rails are locked. See pages 8 and 9 2. Push center of playard down until you hear a click.
A storage pocket has been provided for them on the bottom panel of your unit. Wrap mattress around play yard. Push in on the button located on the side of the top rail to release the two tubes. SI SU CORRALITO ES USADA EN LA PLAYA DEBE PARA LIMPIAR EL CORRALITO PARA LAVAR EL BOLSO PARA TRANSPORTAR PARA LAVAR EL MOISÉS: PARA LAVAR EL MOISÉS:. Be sure all top rails are rigid. Never including an add-on bassinet. Pull up on side rails in middle above push button until all four sides are locked. Reemplace o repare las partes que lo necesiten. Installer le parc Utiliser le parc.
